Clarion K10 Guida di Installazione Scaricare il pdf (Pagina 7)

door lock harness (H4), wire connection guide

___

peripheral plug-in harnesses

LED, 2-pin WHITE plug

The LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port. Make sure the LED wires are

not shorted to ground as the LED will be damaged. Multiple LED’s can be used, but they must be wired

in series. The LED fits into a 9/32-inch mounting hole. Be sure to check for clearance prior to drilling

the mounting hole.

NNOOTTEE::

Never use a BLUE LED in combination with a RED LED.

override switch, 2-pin BLUE plug

The override switch should be accessible from the driver’s seat. It plugs into the BLUE port on the side

of the unit. Consider how the button will be used before choosing a mounting location. Check for rear

clearance before drilling a 9/32-inch hole and mounting the button.

DIA-41

IImmppoorrttaanntt!!

The door lock outputs are low current and should not be attached directly to any

high current device; they are only to be used to activate relays

Blue (-) Unlock, (+) Lock Output

Empty Unless Using Resistor Interface

Green (-) Lock, (+) Unlock Output

H2/A

H2/B

H2/C

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Nessun commento

Clarion K10 Guida di Installazione Pagina 7